Ge-monogram Gas Grill User Manual download pdf (Page 22)

Burner

removal

(on some models)

Ensure the gas supply is off, the knobs are in the

OFF position and all surfaces are cool before

removing a burner.

The grill and range-top burners are cast iron

coated with porcelain enamel. Occasionally

it will be necessary to remove surface rust to

ensure proper performance. Frequency of

cleaning will depend on the climate and

location and how often you use the cooking

center. The walls of the burners are thick so

they can withstand many years of use.

To remove the grill burner(s), remove the grill

rack(s), then lift out the stainless steel radiant

tray(s) with the lava rocks or ceramic briquettes

still on it. Remove wire shipping ties if present.

Grasp the burner, pull it up and slightly to the

rear of the unit so the burner head comes off

the brass orifice at the front. Angle the burner

sideways and remove.(24″ models have two

grill burners.)

To remove the range-top burners (on some

models), remove the top grates. Lift out

aeration pan from around the burners. Lift and

remove the front and rear range-top burners.

The smoker burner (on some models) can be

removed and cleaned by unplugging the igniter

wire and lifting out the burner.

To reassemble the burners, replace the burner

by sliding the air shutters over the brass orifice,

centering it in the hole. It is extremely important

to center the burner on the orifice properly.

Be careful not to upset the air shutters’ original

position (unless readjusting). Lower the rear

of the burner into the cutouts on the support

channel and make sure the locating hole in the

burner end is seated over the pin in the burner

box. Make sure all burners are level and do

not rock.

On 24″ models, to double check if the two

burners are properly seated over the brass

orifices, you can visually inspect them.

1. Remove the two outer control knobs.

2. Remove the two screws underneath the

control knobs and the two screws underneath

the control panel.

3. Rotate the control panel forward. (Do not

remove it.)

4. Shine a flashlight in the gap to make sure the

burners are over the brass orifices. Replace

screws and knobs.

Venturi tube

Flash tubes

Igniter

Burner hanger

Lighter

ports

Air shutters

Range-top burner

Grill burner for 27″, 36″ and 48″ models

Grill burners for 24″ model

Replace the stainless steel radiant tray so that

the slots in the corners of the tray align with

the projections on the top of the burner. (On

24″ models the stainless steel radiant trays sit

level on the side supports.) Make sure that it

sits level and does not rock.

Light all of the burners and check for proper

flame characteristics. (Do not attempt to light

the burners prior to replacing radiant trays,

grills and aeration pans.) If adjustments are

necessary refer to the Installation Instructions.

Care and Cleaning

Stainless Steel Outdoor Cooking Center

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Comments to this Manuals

No comments

Ge-monogram Gas Grill User Manual Page 22

Comments to this Manuals

Related products and manuals for Grills Ge-monogram Gas Grill

Související produkty a manuály pro ne AEG FAV88070VI